#Genie #Remote #Control #Programming #Full #video
In this video we will show you how to program your remote control please be aware this video is only meant to be a visual aid to help you understand the programming of the remote it is not meant to be a substitute for the owner’s manual that came with your new opener or
With the instructions that came with your remote control if you bought it as an accessory please refer to either of them for complete detailed instructions and warning notices please note that a moving door can cause serious injury or death keep people clear of the doors it
Moves and do not allow children to play with the keypad while console or remote controls you should review the manual for other specific safety points before proceeding with installation also keep in mind these additional points when programming your remote control you have 30 seconds to execute each step if you
See two flashing red LEDs on the opener you have run out of time and must go back to the beginning of the step and start over you can restart as many times as necessary step1 required programming remove protective film for battery from the remote insert divisor clip into the
Slot on the back of the remote please note that you should not hold the remote control too close to the opener when programming the remote buttons press and hold the square program set button until the round LED light turns blue long led begins flashing purple press and release the button you have chosen
On the remote to use the long LED that is blinking purple now turns into a solid purple press and release the same button on the remote both the long and round LEDs will flash blue then turn off press and release the same button on the remote the door should open or close and
Your remote is ready to use repeat as necessary for additional remotes to program the same remotes for other openers repeat the steps using the other two remote buttons each remote can be programmed for up to three openers
0 Comments